Ignition Switch
REMOVAL PROCEDUREIgnition Switch Replacement: Removal Procedure:
1. Disconnect the negative battery cable.
2. Apply the parking brake.
3. Remove the console.
4. Remove the I/P accessory trim plate.
5. Remove the driver knee bolster trim panel.
6. Remove the ignition switch lock cylinder electrical connector from the retaining tab on the side of the ignition switch.
Ignition Switch Replacement: Removal Procedure:
7. Disconnect the lock cylinder electrical connector.
Important: Take note of the way in which the ignition switch lock cylinder wire is wrapped around the base of the ignition switch bezel.
8. Remove the ignition switch bezel. Carefully pull to unsnap.
Ignition Switch Replacement: Removal Procedure:
9. Remove the hazard warning switch wiring harness from the ignition switch retainer.
Ignition Switch Replacement: Removal Procedure:
10. Disconnect the ignition switch electrical connectors.
Ignition Switch Replacement: Removal Procedure:
11. Disconnect the park/lock cable (All) from the ignition switch.
11.1. Insert the key into the ignition switch, then turn the ignition to ON.
11.2. Using a flat bladed screwdriver or other suitable tool, depress the park/lock cable retaining tab (located on the underside of the switch near the base of the cable).
11.3. Pull to remove the cable.
Ignition Switch Replacement: Removal Procedure:
12. Remove the ignition switch retaining bolts.
13. Remove the ignition switch.
INSTALLATION PROCEDURE
Ignition Switch Replacement: Installation Procedure:
1. Install the ignition switch into position on the ignition switch housing bracket.
2. Install the ignition switch retaining bolts.
Tighten
Tighten the ignition switch retaining bolts to 5.5 N.m (49 lb in).
Ignition Switch Replacement: Installation Procedure:
3. Install the park/lock cable (A/T) to the ignition switch (still in the ON position).
Push to secure the cable retaining tab.
Ignition Switch Replacement: Installation Procedure:
4. Connect the ignition switch electrical connections.
Ignition Switch Replacement: Installation Procedure:
5. Install the hazard warning switch wiring harness to the ignition switch retainer.
Ignition Switch Replacement: Installation Procedure:
6. Install the ignition switch bezel to the switch.
6.1. Wrap the ignition switch lock cylinder wire around the base of the ignition switch bezel, as noted during removal.
6.2. Align the bezel slots to the lock cylinder pins, then push to secure.
7. Connect the lock cylinder electrical connector.
Ignition Switch Replacement: Installation Procedure:
8. Install the lock cylinder electrical connector to the retaining tab on the side of the ignition switch.
9. Install the driver knee bolster trim panel.
10. Install the I/P accessory trim plate.
11. Install the console.
12. Connect the negative battery cable.
Tighten
Tighten the negative battery cable bolt to 15 N.m (11 lb ft).
13. Program the transmitters. Refer to Transmitter Programming/Synchronization in Keyless Entry.
14. Release the parking brake.