General Service Instructions

- Do not expose the inflator modules to temperatures above 65°C (15°F).
- Verify the correct replacement part number. Do not substitute a component from a different vehicle.
- Do not repair any of the following components. Service the following components by replacement only:
- The inflatable restraint sensing and diagnostic module (SDM)
- The inflatable restraint IP (inflator) module
- The inflatable restraint steering wheel (inflator) module
- The inflatable restraint steering wheel module coil
- The inflatable restraint front end discriminating sensor
- Use only new or remanufactured parts from an authorized original equipment manufacturer dealer. Do not use salvaged parts for repairs to the SIR system.
- Do not install any of the following components if the components have been dropped from a height of 91 centimeters (3 feet) or greater. Discard the component:
- The inflatable restraint Sensing and Diagnostic Module (SDM)
- The inflatable restraint Instrument Panel (IP) (inflator) module
- The inflatable restraint steering wheel (inflator) module
- The inflatable restraint steering wheel module coil
- The inflatable restraint front end discriminating sensor
- When you replace the SDM, verify that the following conditions are met:
- The mounting surface is clean.
- The arrow on the module points toward the front of the vehicle.
- The module is flat on the mounting surface, parallel to the vehicle datum line.
- The module fasteners are installed and tightened as specified.
- In order to avoid setting false diagnostic trouble codes, only apply power to the SIR system when 1 of the following 2 conditions is met:
- All SIR system components are properly mounted and electrically connected.
- A diagnostic procedure directs you to apply power.
- Begin diagnosis of malfunctions with the SIR Diagnostic System Check. Perform the SIR Diagnostic System Check in order to verify the following items:
- The proper operation of the AIR BAG warning lamp.
- Communication with the SDM through the serial data line.
- The presence or absence of diagnostic trouble codes.
- Whether additional diagnosis is required and where the information resides.
- Not beginning with the SIR Diagnostic System Check may result the following conditions:
- Extended diagnostic time
- Incorrect diagnosis
- Unneeded parts replacement