Hazard Lamps

The HAZARD Fuse receives voltage at all times. When the Hazard Switch is pressed to ON, voltage is applied through its closed contacts from the HAZARD Fuse to the Turn Relay. The Turn Relay is grounded through the Junction Block at G203. The Turn Relay contains a solid state timer/relay. When the Hazard Switch is pressed to ON, the solid state timer/relay receives a ground signal through the LH and RH Front and Rear Turn Lamps. When the timer/relay receives this signal, voltage is applied through the Turn Relay and the Hazard Switch to the LH and RH Front and Rear Turn Lamps along with the LH and RH Turn Indicators. The LH and RH Front and Rear Turn Lamps are all permanently grounded. The solid state timer/relay will flash the Turn Lamps approximately 80-90 times per minute.