Body Hinge Pillar Tie Bar - Cross Car Beam Replacement

Instrument Panel And Front Floor Console:

Instrument Panel And Front Floor Console Legend:

Front Floor Console:

REMOVE OR DISCONNECT
1. Instrument panel trim pad.
2. Bolts/screws from cross car beam center support to instrument panel tie bar.
3. Cross car beam from vehicle.

INSTALL OR CONNECT

NOTE: Refer to Fastener Notice in Cautions and Notices.

1. Cross car beam to vehicle.
2. Position cross car beam center support to lower instrument panel tie bar.
3. Bolts/screws to cross car beam center support to lower instrument panel tie bar.

Tighten
^ Bolts/screws to 2 Nm (18 lb in).

4. Instrument panel trim pad.