Instrument Panel Accessory Trim Plate

Instrument Panel Trim Plate (Typical):

REMOVE OR DISCONNECT
1. Bolts/screws from lower instrument panel accessory trim plate.
2. Pull instrument panel accessory trim plate rearward to release retainers.
3. Rotate instrument panel accessory trim rearward and up to release tabs at top edge.

INSTALL OR CONNECT

NOTE: Refer to Fastener Notice in Cautions and Notices.

1. Tabs at top edge into instrument panel.
2. Rotate forward and press clips into place.
3. Bolts/screws to lower instrument panel accessory trim plate.


Tighten
^ Bolts/screws to 2 Nm (18 lb in).