4T60-E Automatic Transaxle

REMOVAL PROCEDURE





1. Raise and support the vehicle. Refer to Vehicle Lift Points.
2. Remove the right front tire and wheel. Refer to Wheel Removal in Wheels and Tires.
3. Remove the right engine splash shield.
4. Remove the vehicle speed sensor wiring harness connector.





5. Remove the vehicle speed sensor bolt (9).
6. Remove the vehicle speed sensor (10) from the extension case.





7. Remove the O-ring (11) from the vehicle speed sensor (10).

INSTALLATION PROCEDURE





1. Install the O-ring (11) to the vehicle speed sensor (10).
2. Install the vehicle speed sensor (10) to the extension case.





3. Install the vehicle speed sensor bolt (9).
^ Tighten the vehicle speed sensor bolt to 11 Nm (97 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.





4. Install the vehicle speed sensor wiring harness connector.
5. Install the right engine splash shield.
6. Install the right front tire and wheel. Refer to Wheel Installation in Wheels and Tires.
7. Lower the vehicle.