Instrument Panel (IP) - Accessory Trim Plate Replacement

REMOVAL PROCEDURE



1. Unsnap the instrument panel accessory trim plate (2).
2. Remove the electrical connectors (1) from the switches (3), if equipped.




3. Remove the fog lamp or second gear start switch located in position 1, if equipped.




4. Remove the second gear start, rear fog lamp, or traction control switch located in position 2, if equipped.

INSTALLATION PROCEDURE



1. Install the second gear start, rear tog lamp, or traction control switch located in position 2, if equipped.




2. Install the fog lamp or second gear start switch located in position 1, if equipped.




3. Install the electrical connectors (1) to the switches (3), if equipped.
4. Snap the instrument panel accessory trim plate (2) to the I/P.