Replacement

Caution: The child seat tether anchor is intended for use only on the left or right outboard second row seats. Installation at any other
seating position could result in system failure, leading to injury in the event Of a collision.

Caution: The seat belt assembly and/or bracket assembly must be replaced as a unit only. Do not substitute parts for any reason, or
personal injury could result.

Important: Replace the anchor bracket it the anchor bracket is damaged.

1. Remove the bolts/screws (1).
2. Remove the anchor bracket (3).

Installation Procedure
1. Connect the anchor bracket (3) to the anchor bracket mounting plate.

Notice: Refer to Fastener Notice in Cautions and Notices.

Important: DO NOT use a nut driver to tighten this hardware or the fasteners will not be properly seated.

2. Install the bolts/screws (1).
Tighten the bolts/screws (1) until the bolts are fully seated. Do not strip the bolts