Cruise Control Module: Service and Repair

The cruise control module assembly is mounted on the right front strut tower. The module assembly has an electronic controller and an electric stepper motor in order to vary the throttle with each different cruise control mode. The module assembly is not serviceable.

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Disconnect the cruise control cable. Refer to Cruise Control Cable Replacement (LD9). Service and Repair
3. Disconnect the electrical connector from the module assembly.
4. Remove the module retaining nuts.
5. Remove the module (1) from the mounting bracket.
6. Remove the module assembly from the front of the dash.

Installation Procedure

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Do not pre-tap screws to the module without mounting a bracket in between the module and the screw. The added length of the screw may damage the cruise control module.

1. Install the module assembly (1) to the front of the dash.

Tighten
Tighten the nuts to 12 N.m (106 lb in).

2. Connect the electrical connector to the module.
3. Install the cruise control cable.
4. Adjust the cruise control cable. Refer to Cruise Control Cable Replacement (LD9). Service and Repair
5. Connect the negative battery cable.