Fuel Level Sensor: Service and Repair

Fuel Level Sensor Replacement

REMOVAL PROCEDURE
1. Relieve fuel system pressure.
2. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
3. Remove the fuel tank.
4. Remove the modular fuel sender assembly.
5. Remove the fuel level sensor from the modular fuel sender.

INSTALLATION PROCEDURE

1. Install the fuel level sensor to modular fuel sender.
2. Install the fuel sender assembly.
3. Install the fuel tank.
4. Refill the fuel tank.
5. Connect the negative battery cable.
6. Inspect for fuel leaks through the following steps:
6.1. Turn the ignition switch to the ON position for 2 Seconds
6.2. Turn the ignition switch to the OFF position for 10 Seconds.
6.3. Turn the ignition switch to the ON position
6.4. Check for fuel leaks.