Closeout/Insulator Panel Replacement - Lower (RH)

REMOVAL PROCEDURE



1. Using a flat bladed tool, carefully pry the I/P courtesy lamp assembly from the RH lower closeout panel.




2. Remove the RH lower closeout panel push-in retainers from the I/P lower support beam.
3. Lower the closeout panel slightly, and finesse the left side of the closeout panel from above the driveline tunnel.
4. Insert the I/P courtesy lamp assembly up through the opening in the closeout panel.
5. Continue to lower the closeout panel, then pull to remove from the dash panel studs.
6. Remove the closeout panel.

INSTALLATION PROCEDURE



1. Install the RH closeout panel onto the dash panel studs.
2. Insert the I/P courtesy lamp down through the opening in the closeout panel.
3. Raise the closeout panel slightly, and finesse the left side of the closeout panel into position above the driveline tunnel.
4. Install the closeout panel push-in retainers to the I/P lower support beam.




5. Align the I/P courtesy lamp to the closeout panel opening, then push to secure.