Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.




1. Disconnect the negative battery cable.
2. Raise the vehicle.
3. Remove the starter.
4. Disconnect the Crankshaft Position (CKP) sensor electrical connector.





IMPORTANT: Clean the area around the CKP before removal in order to avoid debris from entering the engine.

5. Remove the CKP sensor retaining bolt.
6. Remove the CKP sensor.

INSTALLATION PROCEDURE




1. Install the CKP sensor.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the CKP sensor retaining bolt.

Tighten
Tighten the CKP sensor to 25 N.m (18 lb ft).




3. Connect the CKP sensor electrical connector.
4. Install the starter.
5. Lower the vehicle.
6. Connect the negative battery cable.
7. Perform the idle learn procedure. Refer to PCM Idle Learn Procedure.
8. Program the transmitters. Refer to Transmitter Programming/Synchronization in Keyless Entry. Testing and Inspection