Ignition Control Module: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Disconnect the 14-way connector from the ignition control module.
3. Disconnect the spark plug wires from the coil assemblies (note the position that the wires were removed.
4. Remove 6 screws (1) securing the coil assemblies to the ignition control module.
5. Remove the coils (2) from the ignition control module (3).
6. Remove the 2 nuts and washers under the module bracket.
7. Remove the ignition control module.

INSTALLATION PROCEDURE
1. Attach the coils to the ignition control module and position the module on the module bracket. Refer to Ignition Coil(s) Replacement.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install 6 ignition coil attaching screws.

Tighten
Tighten the screws to 4 - 5 N.m (40 lb in).

3. Install the nuts and washers securing the ignition control module assembly to the mounting bracket.

Tighten
Tighten the nuts to 8 N.m (70 lb in).

4. Connect the spark plug wires.
5. Connect the 14-way connector to module.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

6. Reconnect the negative battery cable.