Blower Motor Resistor: Service and Repair

REMOVAL PROCEDURE
1. Remove the right side instrument panel insulator.
2. Disconnect the electrical connector from the blower motor resistor.
3. Remove the blower motor resistor attaching bolts.
4. Remove the blower motor resistor.

INSTALLATION PROCEDURE
1. Install the blower motor resistor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the blower motor resistor attaching bolts.

Tighten
Tighten the blower motor resistor bolts to 10 N.m (89 lb in).

3. Connect the electrical connector to the blower motor resistor.
4. Install the right side instrument panel insulator.