Throttle Position Sensor: Service and Repair
REMOVAL PROCEDURE1. Disconnect the TP sensor electrical connector.
2. Remove the 2 TP sensor attaching screws.
3. Remove the TP sensor.
4. Remove the TP sensor O-ring.
INSTALLATION PROCEDURE
1. Install the TP sensor O-ring.
2. With the throttle valve in the normal closed idle position, install the TP sensor on the throttle body assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the 2 TP sensor attaching screws, using a thread-locking compound on the screws. Loctite(R) 262 GM P/N. 1052624, or equivalent should be used.
Tighten
Tighten the TP sensor attaching screws to 2.0 N.m (18 lb in).
4. Connect the TP sensor electrical connector.