Crankshaft Position (CKP) Sensor Replacement (7X)

Crankshaft Position Sensor Replacement (7X)

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Crank steering wheel fully to the left.
3. Raise the vehicle. Refer to Vehicle Lifting in Service Precautions.
4. Disconnect the sensor electrical connector.
5. Remove the attaching Bolt/screw.
6. Remove the sensor from engine.
7. Inspect for wear, cracks, or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil before installation and replace if damaged.
2. Install the sensor to the block.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Reinstall the sensor attaching Bolt.

Tighten
Tighten the bolt to 8 N.m (71 lb in).

4. Connect the sensor electrical connector.
5. Lower the vehicle.
6. Reconnect the negative battery cable.