Throttle Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the TP sensor electrical connector.




2. Remove the 2 TP sensor attaching screws.




3. Remove the TP sensor.




4. Remove the TP sensor O-ring.

INSTALLATION PROCEDURE




1. Install the TP sensor O-ring.




2. With the throttle valve in the normal closed idle position, install the TP sensor on the throttle body assembly.






NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the 2 TP sensor attaching screws, using a thread-locking compound on the screws. Loctite� 262, GM Part No.1052624, or equivalent should be used.

Tighten
Tighten the TP sensor attaching screws to 2.0 N.m (18 lb in).




4. Connect the TP sensor electrical connector.