Camshaft Position Sensor: Service and Repair

Locations View:

Camshaft Position Sensor Replacement

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the serpentine drive belt.
3. Disconnect the sensor electrical connector.
4. Remove the attaching bolt.
5. Remove the sensor.
6. Inspect the sensor for wear, cracks or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil and replace it damaged.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the camshaft Position Sensor.

Tighten
Tighten the retaining bolt to 10 N.m (8 lb ft).

3. Connect the sensor electrical connector.
4. Reinstall the serpentine drive belt.
5. Reconnect the negative battery cable.