Sedan

REMOVAL PROCEDURE




1. Remove the armrest pull cup mounting screw.

CAUTION: Disconnect the power window switch when working inside the drivers door. When operated, the Express Down feature allows the door window to drop very quickly, which could cause personal injury.

IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

IMPORTANT: Use protective coating/tape at the point of insertion of the flat surface tool.

2. Remove the pull cup from the inner trim panel. Use a flat-bladed tool.
3. Disconnect the electrical connector.




4. Unsnap the power window switch from the pull cup.

INSTALLATION PROCEDURE




1. Snap the power window switch into the pull cup.
2. Connect the electrical connector.




3. Snap the pull cup into the inner trim panel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

4. Install the armrest pull cup screw.

Tighten
Tighten the armrest pull cup screw to 3 N.m (30 lb in).