Air Cleaner Housing: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the IAT sensor electrical connector (1).
2. Remove the air hose (2) from the air cleaner cover.
3. Remove the accelerator cable from the accelerator cable guide clip (attached to the air cleaner cover).
4. Loosen the two air inlet duct clamps (4).
5. Release the two air cleaner cover hold down clips (3).




6. Remove the air cleaner cover (1).
7. Remove the air inlet duct (4).
8. Remove the air filter (2).
9. Remove the three bolts from the air cleaner lower assembly.
10. Remove the air cleaner lower assembly (3) from the vehicle.

INSTALLATION PROCEDURE




1. Install the air cleaner lower assembly (3) to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Secure the air cleaner lower assembly to the vehicle with three bolts.

Tighten
Tighten the three bolts to 18 N.m (13 lb ft).

3. Install the air filter (2) to the air cleaner lower assembly (3).
4. Install the air inlet duct (4).
5. Install the air cleaner cover (1) onto the air cleaner lower assembly (3).




6. Fasten the two air cleaner cover hold down clips (3).
7. Install the air inlet duct to the air cleaner cover and tighten the two clamps (4).
8. Insert the accelerator cable into the accelerator cable guide clip (attached to the air cleaner cover).
9. Install the air hose (2) to the air cleaner cover.
10. Connect the IAT sensor electrical connector (1).