Automatic Transmission-4 Speed-MS7

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative (-) battery cable.
2. Disconnect the vehicle speed sensor (VSS) electrical connector.





3. Remove 1 retaining bolt (1) and VSS (2) from the transaxle.
4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.

Installation Procedure

^ Tools Required
- J36850 TRANSJEL(R) Transmission Assembly Lubricant.

1. Apply J36850 to the VSS O-ring.

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS (2) with the retaining bolt (1).
^ Tighten the VSS speed sensor (VSS) bolt to 6 Nm (53 inch lbs.).
3. Connect the VSS electrical connector.
4. Connect the negative (-) battery cable.