Manual Transmission-MB4 and MB5

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.





2. Disconnect the vehicle speed sensor (VSS) electrical connector (1).
3. Remove 1 retaining bolt and the VSS from the transaxle.
4. Inspect the VSS O-ring for cuts or damage. Replace as necessary.

Installation Procedure

^ Tools Required
- J36850 Transmission Assembly Lubricant

1. Apply J36850 to the VSS O-ring.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the Vehicle Speed Sensor (VSS) into the transaxle case. Secure the VSS with the retaining bolt.
^ Tighten the VSS speed sensor (VSS) bolt to 6 Nm (53 inch lbs.).





3. Connect the VSS electrical connector (1).
4. Connect the negative (-) battery cable.