Removal and Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect caution in Service precautions.




1. Disconnect the negative battery cable.




2. Remove the headlamp housing bracket bolt attaching the headlamp to the headlamp bracket.
3. Slide the headlamp outboard to disengage the headlamp tabs from the headlamp brackets slots.




4. Pull the headlamp forward to access electrical connectors.
5. Disconnect the electrical connectors from the headlamp.
6. Remove the headlamp.

INSTALLATION PROCEDURE




1. Perform the following to install the headlamp:
1.1. Connect the electrical connector to the headlamp.
1.2. Engage tabs on back of headlamp into the slots in the headlamp bracket.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the headlamp housing bracket bolt attaching the headlamp to the headlamp bracket.

Tighten
Tighten the headlamp housing bracket bolt to 7 N.m (62 lb in).




3. Connect the negative battery cable.