Backup Lamp: Service and Repair

REMOVAL PROCEDURE
1. Turn the back-up lamp bulb counter-clockwise.
2. Pull the back-up lamp bulb from the socket.
3. Remove the electrical connector (5).
4. Remove the retaining screws (1).
5. Remove the assembly.

INSTALLATION PROCEDURE
1. Align the tabs (6).
2. Turn the back-up lamp bulb clockwise into the socket.
3. Connect the electrical connector (5).

NOTE: Refer to Fastener Notices in Service Precautions

4. Install the retaining nuts (1).

Tighten
Tighten the retaining nuts to 2 N.m (18 in lb).