Instrument Panel Cluster (IPC) - Replacement

Instrument Cluster Replacement

Removal Procedure

1. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the cluster trim plate.




3. Remove the screws attaching the cluster (2).
4. Pull the cluster (2) rearward in order to remove the cluster.
5. Disconnect the electrical connector.

Installation Procedure




1. Connect the electrical connector.
2. Install the cluster (2) to the instrument panel (1).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the IP cluster attaching screws.

Tighten the IP cluster to 2 N.m (18 lb in).

4. Install the cluster trim plate.
5. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.