Crankshaft Position (CKP) Sensor Replacement (24X)

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the serpentine drive belt from the crankshaft pulley.
3. Raise the vehicle on hoist. Refer to Lifting and Jacking the Vehicle in General Information.
4. Remove the crankshaft harmonic balancer.
5. Note the routing of sensor harness before removal.
6. Remove the harness retaining clip (3) and the bolt (4).
7. Disconnect the sensor electrical connector.
8. Remove the sensor bolts (4).
9. Remove the sensor (1).

INSTALLATION PROCEDURE
1. Install the 24X crankshaft position sensor (1) and bolts (4) and route the harness as noted during removal.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the harness retaining clip with the bolt (3).

Tighten
Tighten the bolts to 10 N.m (8 lb ft).

3. Connect the sensor electrical connector.
4. Reinstall the balancer on the crankshaft.
5. Lower the vehicle.
6. Install the serpentine drive belt.
7. Perform the CKP System Variation Learn Procedure. Programming and Relearning