C1247

Circuit Description
When the master cylinder is low on brake fluid the brake fluid level indicator switch grounds the circuit and turns on the RED brake indicator in the instrument cluster, then the instrument cluster sends a class 2 message to the EBCM. If the low brake fluid message is sent from the IPC to the EBCM, TCS will be disabled and a Diagnostic Trouble Code (DTC) sets.

Conditions for Running the DTC
The ignition is ON.

Conditions for Setting the DTC
The EBCM receives a class 2 message from the instrument cluster.

Action Taken When the DTC Sets
^ The EBCM disables the TCS for the duration of the ignition cycle.
^ The Traction Off indicator turns ON.
^ The message center displays the Service Traction System message.

Conditions for Clearing the DTC
Condition for DTC is no longer present or scan tool clear DTC function is used.

Diagnostic Aids
^ Possible causes for DTC C1247 to set are:
- Any leaks in hydraulic brake system (such as brake pipes, wheel cylinders, calipers, or master cylinder).
- Brake fluid level indicator switch malfunction.
- Brake fluid level indicator input circuit is short to ground.
^ It is very important that a thorough inspection of the wiring, connectors, and the hydraulic brake system components be performed. Failure to carefully and fully inspect wiring, connectors, and hydraulic brake system components may result in misdiagnosis, causing part replacement with reappearance of the malfunction.
^ If an intermittent malfunction exists refer to Testing for Intermittent and Poor Connections in Diagnostic Aids under Diagrams.