Glove Compartment: Service and Repair
Instrument Panel Compartment Replacement
Removal Procedure
1. Remove the screws from the instrument panel (IP) compartment.
2. Open the IP compartment. Disconnect the IP damper cable from the IP compartment tab.
3. Depress the side stops located on the sides of the IP compartment.
4. Carefully remove the IP compartment.
Installation Procedure
1. Align the IP compartment to the opening.
Depress the side stops located on the sides of the IP compartment.
Install the IP compartment to the IP compartment opening.
2. Connect the IP damper cable to the IP compartment tab.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the IP compartment screws.
Tighten the screws to 2 Nm (18 lb in).
4. Close the IP compartment. Verify that the IP compartment is properly aligned. Adjust the compartment as required.