Underhood Lamp: Service and Repair

Underhood Lamp Replacement





REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Disconnect the electrical connector from the underhood lamp.
3. Remove the harness retainers from the hood using a small flat-bladed tool.
4. Remove the harness retainers from the shock tower using a small flat-bladed tool.
5. Apply pressure to the retainer behind the connector on the underhood lamp using a small flat-bladed tool.
6. Remove the underhood lamp from the hood.

INSTALLATION PROCEDURE
1. Install the underhood lamp to the hood.
2. Align the tab at the top of the underhood lamp to the slot in the hood. Push in the tab.
3. Align the lower snap tab at the bottom of the underhood lamp to the slot in the hood. Press down the tab.
4. Install the harness retainers to the hood.
5. Install the harness retainers to the shock tower.
6. Connect the electrical connector to the underhood lamp.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

7. Connect the negative battery cable.