BCM Outputs

The BCM directly controls these outputs, plus other systems may request the BCM to control these outputs for certain functions:
^ All Door Lock: This output supplies voltage to the door lock actuators when the doors are commanded to lock. This output also supplies ground to all the door lock actuators when the doors are commanded to unlock.
^ Backup Lamp Relay Control: Provides ground to the Backup LP relay control circuit.
^ BTSI Solenoid Control: Provides ground to the Brake Transaxle Shift Interlock Control Solenoid.
^ Door Unlock: This output supplies voltage to the door lock actuators (except the driver door lock actuator) when the doors are commanded to unlock. This output also supplies ground to all the door lock actuators (except the driver door lock actuator) when the doors are commanded to lock.
^ Driver Door Unlock: This output supplies voltage to the driver door lock actuators when the doors are commanded to unlock. This output also supplies ground to the driver door lock actuator when the doors are commanded to lock.
^ DRL Relay Control: Provides ground to the DRL relay control circuit.
^ DRL 5 V Reference: Provides 5 Volts to the ambient light sensor.
^ Inadvertent Load Relay Control Output: Supplies ground to the battery rundown protection relay providing an inadvertent load (battery rundown) protection.
^ Fog Lamp Enable Control: Sends a ground signal to the fog lamp switch when the ignition switch on; this action enables the fog lamp switch. The fog lamps turn on when the fog lamp switch is enabled by the BCM.
^ Headlamp Relay Control: Provides ground to the Headlamp relay control circuit.
^ Horn: Sends a ground signal to the horn relay, sounding the horn for the keyless entry alarm function or the content theft system.
^ Inadvertent Relay Control: Provides ground to the Battery Rundown Protection relay control circuit.
^ Interior Dimming: Controls the voltage to the interior lights dimming system.
^ Load Management Control: Provides voltage to the Rear Defogger relay control circuit and the Heated Seats.
^ Park Lamp Relay Control: Provides ground to the Park Lamp relay control circuit.
^ Passlock Sensor Power: Provides B+ for Passlock sensor operation.
^ Passlock Sensor Ground: Provides ground to the Passlock sensor.
^ RAP Relay Control: Provides voltage to the RAP relay control feed circuit.
^ Rear Compartment Lid Release Output: Provides ground to Rear Compartment Lid Release Actuator.
^ RFA Link: Provides an interface allowing the transfer of keyless entry information to the Remote Control Door Lock Receiver (RCDLR).
^ Serial Data: provides an interface with the PCM, EBCM, Radio, SDM, DIC and the IPC through the Class 2 serial data link.
^ Theater Dimming 1 Control: Supplies ground to activate the Footwell lamps.
^ Theater Dimming 2 Control: Supplies ground to activate the inside rear view mirror lamps, non SEO dome lamp, and the roof rail courtesy/reading lamps.