Air Cleaner Housing: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the electrical connector (1) from the Intake Air Temperature (IAT) sensor.
2. Remove the air hose (2) from the air cleaner cover.
3. Remove the accelerator cable from the accelerator cable guide clip.
4. Loosen the 2 air inlet duct clamps (4).
5. Release the 2 air cleaner cover hold-down clips (3).




6. Remove the air cleaner cover (1).
7. Remove the air inlet duct (4).
8. Remove the air filter (2).
9. Remove the 3 bolts from the air cleaner lower assembly.
10. Remove the air cleaner lower assembly (3) from the vehicle.

INSTALLATION PROCEDURE




1. Install the air cleaner lower assembly (3) to the vehicle.

NOTE: Refer to Fastener Notice in Service and Precautions.

2. Secure the air cleaner lower assembly to the vehicle with 3 bolts.

Tighten
Tighten the 3 bolts to 18 N.m (13 lb ft).

3. Install the air filter (2) to the air cleaner lower assembly (3).
4. Install the air inlet duct (4).
5. Install the air cleaner cover (1) onto the air cleaner lower assembly (3).




6. Fasten the 2 air cleaner cover hold-down clips (3).
7. Install the air inlet duct to the air cleaner cover and tighten the clamps (4).
8. Insert the accelerator cable into the accelerator cable guide clip attached to the air cleaner cover.
9. Install the air hose (2) to the air cleaner cover.
10. Connect the IAT sensor electrical connector (1).