Instrument Panel Cluster (IPC) - Trim Plate Bezel Replacement

REMOVAL PROCEDURE

CAUTION: When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system Refer to Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.




1. Disable the supplemental inflatable restraint (SIR) system. Refer to Disabling the SIR System in Restraint Systems.
2. Remove the instrument panel (IP) insulator.
3. Remove the knee bolster deflector.
4. Loosen the steering column upper support nuts.
5. Lower the steering column.
6. Remove the IP cluster trim bezel screws.
7. Remove the IP cluster trim bezel.

INSTALLATION PROCEDURE




1. Install the IP cluster trim bezel.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the IP cluster trim bezel screws.

Tighten
Tighten the screws to 2 N.m (18 lb in).

3. Raise the steering column.
4. Install the steering column upper support nuts.

Tighten
Tighten the nuts to 25 N.m (18 lb ft).

5. Install the knee bolster deflector.
6. Install the IP insulator.
7. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.