Recirculation Door Replacement

REMOVAL PROCEDURE
1. Remove the IP trim pad.
2. Remove the SIR bracket.
3. Disconnect the recirculation actuator vacuum hose.
4. Remove the recirculation housing screws.
5. Tilt the recirculation housing away from the HVAC module and lift housing from the tab slots in the module case.
6. Remove the recirculation actuator.
7. Remove the recirculation door from the recirculation housing.

INSTALLATION PROCEDURE
1. Install the recirculation door into the recirculation housing.
2. Install the recirculation actuator.
3. Install the recirculation housing to the HVAC module.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the recirculation housing screws.

Tighten
Tighten the screws to 1.6 N.m (14 lb in).

5. Connect the recirculation actuator vacuum hose.
6. Install the SIR bracket.
7. Install the IP trim pad.