Crankshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the right splash shield cover.
4. Remove the crankshaft harmonic balancer.
5. Disconnect the sensor electrical connector.
6. Remove the crankshaft position sensor (CKP) shield (1).




7. Remove the CKP sensor bolts.
8. Remove the CKP sensor.

INSTALLATION PROCEDURE




1. Position the CKP sensor to the block.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CKP sensor bolts.

Tighten
Tighten the bolts to 30 N.m (22 lb ft).




3. Install the CKP sensor shield (1).
4. Connect the CKP sensor electrical connector.
5. Install the crankshaft balancer.
6. Install the right splash shield cover.
7. Lower the vehicle.
8. Connect the negative battery cable.
9. Perform the Crankshaft Variation Learn Procedure. Programming and Relearning