Crankshaft Position (CKP) Sensor Replacement (7X)

REMOVAL PROCEDURE




1. Turn OFF the ignition.
2. Crank the steering wheel fully to the left.
3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
4. Remove the right front wheel.
5. Disconnect the crankshaft position (CKP) sensor.
6. Remove the attaching bolt.
7. Remove the sensor from the engine.
8. Inspect for wear, cracks, or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE




1. Lubricate the O-ring with clean engine oil before installation and replace the O-ring if necessary.
2. Install the CKP sensor to the block.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the sensor attaching bolt.

Tighten
Tighten the bolt to 11 N.m (97 lb in).

4. Connect the CKP sensor electrical connector.
5. Install the right front wheel.
6. Lower the vehicle.