Instrument Panel Electrical Center
INSTRUMENT PANEL ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the right door sill plate.
3. Remove the floor kick-up pad on the passenger side.
4. Remove the retaining bolt which secures the multi-use bracket to the electrical wiring junction block.
5. Disengage the retaining clip from the outboard side, twist the electrical wiring block, and pull outward.
6. Remove the battery cable lead.
7. Disconnect 3 64-way block connectors and 3 I/P wiring harness connectors.
8. Transfer all fuses and relays as required.
INSTALLATION PROCEDURE
1. Position the electrical wiring junction block and connect 3 I/P wiring harness connectors and 3 64-way block connectors.
2. Install the electrical wiring junction block to the multi-use bracket with the retaining bolt.
3. Install the battery cable lead.
4. Install the floor kick-up pad on the passenger side.
5. Install the right door sill plate.
6. Connect the negative battery cable.