Crankshaft Position (CKP) Sensor Replacement (24X)

REMOVAL PROCEDURE

24X Crankshaft Position (CKP) Sensor:

1. Turn OFF the ignition.
2. Raise the vehicle on hoist. Refer to Vehicle Lifting.
3. Remove the crankshaft harmonic balancer.
4. Note the routing of sensor harness before removal.
5. Remove the harness retaining clip with bolt.
6. Disconnect the sensor electrical connector.
7. Remove the sensor bolts (4).
8. Remove the sensor.

INSTALLATION PROCEDURE

24X Crankshaft Position (CKP) Sensor:

1. Install the 24X crankshaft position sensor (1) with bolts (4) and route harness as noted during removal.
2. Install the harness retaining clip (3) with bolt (4).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the CKP sensor bolts to 10 N.m (89 lb in).

3. Connect the sensor electrical connector.
4. Install the balancer on the crankshaft.
5. Lower vehicle.
6. Perform the CKP System Variation Learn Procedure. Programming and Relearning