Manifold Pressure/Vacuum Sensor: Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the screws that attach the MAP sensor to the bracket.
3. Disconnect the MAP sensor electrical connector.
4. Disconnect the MAP inlet vacuum hose.
5. Remove the MAP sensor from the bracket.
INSTALLATION PROCEDURE
1. Position the MAP sensor to the bracket.
2. Connect the MAP inlet vacuum hose.
3. Connect the MAP sensor electrical connector.
4. Install the retaining bolt.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the retaining bolt to 3 N.m (27 lb in).