Traction Control Switch: Service and Repair

Traction Control Switch Replacement (Monte Carlo)

Removal Procedure





1. Apply the parking brake.
2. Remove the center console mat.
3. Position the transaxle shift control lever as required.
4. Remove the front floor console trim plate screw (1).
5. Lift the front floor console trim plate up and rearward for access to the traction control switch.





6. Disconnect the electrical connector from the traction control switch.
7. Remove the traction control switch from the floor console trim plate.

Installation Procedure





1. Install the traction control switch to the floor console trim plate.
2. Connect the electrical connector to the traction control switch.





3. Carefully install the floor console trim plate. Make sure all of the retainers are fully engaged.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the floor console trim plate screw (1).
^ Tighten the floor console trim plate screw to 2 Nm (18 inch lbs.).
5. Position the transaxle shift control lever to Park.
6. Install the center console mat.
7. Release the park brake.