I/P Electrical Center or Junction Block Replacement - Left
I/P ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT - LEFTREMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Adjust the instrument panel (IP) cluster trim plate for access.
3. Disconnect the body wiring harness from the junction block.
4. Remove the junction block bolts.
5. Remove the junction block tab from the slot in the cross vehicle beam. Pull the junction block away from the IP.
6. Disconnect the body wiring harness from the junction block.
7. Remove the junction block.
INSTALLATION PROCEDURE
1. Connect the body wiring harness to the junction block.
2. Install the junction block tab to the slot in the cross vehicle beam.
3. Install the junction block bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the junction block bolts to 10 N.m (89 lb in).
4. Connect the body wiring harness to the junction block.
Tighten
Tighten the body wiring harness connector bolt to 7 N.m (62 lb in).
5. Install the instrument panel (IP) cluster trim plate.
6. Connect the negative battery cable.