Ignition Switch Housing Bracket - Dash Mounted

IGNITION SWITCH HOUSING BRACKET REPLACEMENT

REMOVAL PROCEDURE
1. Remove the console.




2. Remove the IP accessory trim plate.
3. Remove the driver knee bolster trim panel.
4. Remove the IP upper trim pad.
5. Remove the ignition switch lock cylinder.
6. Remove the bolts retaining the ignition switch to the ignition switch housing bracket.
7. Reposition the ignition switch.




8. Remove the inside air temperature sensor aspirator duct, if equipped.
8.1. Depress the duct retaining tab and remove the duct from the ignition switch housing bracket.
8.2. Use a twisting motion to release the duct from the duct muffler.




9. Mark the location of the ignition switch housing bracket. Refer to Instrument Panel (I/P) Disassembly Precautions.

IMPORTANT: The following step must be performed to assure proper trim fits during installation.

10. Remove the bolt retaining the ignition switch housing bracket to the steering column bracket.




11. Remove the bolts retaining the ignition switch housing bracket to the IP center support bracket.
12. Remove the ignition switch housing bracket.

INSTALLATION PROCEDURE




1. Install the ignition switch housing bracket into position as marked prior to removal.
2. Install the bolts retaining the ignition switch housing bracket to the IP center support bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the ignition switch housing bracket to IP center support bracket bolts to 12 Nm (106 lb in).




3. Install the bolt retaining the ignition switch housing bracket to the steering column bracket.

Tighten
Tighten the ignition switch housing bracket to steering column bracket bolt to 1.9 Nm (17 lb in).




4. Install the inside air temperature sensor aspirator duct, if equipped.
4.1. Use a twisting motion to secure the duct to the duct muffler.
4.2. Install the duct retaining tab to the ignition switch housing bracket.




5. Install the ignition switch to the ignition switch housing bracket.
6. Install the ignition switch retaining bolts.

Tighten
Tighten the ignition switch retaining bolts to 5.5 Nm (49 lb in).

7. Install the ignition switch lock cylinder.
8. Install the IP upper trim pad.
9. Install the driver knee bolster trim panel.
10. Install the IP accessory trim plate.
11. Install the console.