Power Window Switch: Service and Repair

Front Door Switch Replacement

Removal Procedure






Notice: Apply protective coating/tape at the insertion point of the small flat-bladed tool in order to prevent damage to the inner door trim panel.

1. Pry up the rear edge of the driver side switch assembly, the front edge of the passenger side switch assembly.
2. Slide the driver side switch assembly rearward, the passenger side switch assembly forward, out of the door trim panel.
3. Disconnect the electrical connector.
4. If replacing a bulb, insert a small screwdriver into the slot in the base of the bulb and turn counterclockwise to remove the bulb.

Installation Procedure




1. If replacing a bulb, insert a bulb into the back of the switch and turn the bulb clockwise to secure.
2. Connect the electrical connector to the switch.
3. Insert the front edge of the driver side switch, the rear edge of the passenger side switch, into the door trim panel.
4. Press the rear edge of the driver side switch, the front edge of the passenger side switch, into the trim panel to secure.