Crankshaft Position (CKP) Sensor Replacement (7X)

CRANKSHAFT POSITION (CKP) SENSOR REPLACEMENT (7X)

REMOVAL PROCEDURE




1. Turn the steering wheel fully to the left.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the right front wheel.
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Remove the CKP sensor bolt.
6. Remove the CKP sensor.
7. Inspect for wear, cracks, or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil before installation and replace the O-ring if necessary.




2. Install the CKP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the CKP sensor bolt.

Tighten
Tighten the bolt to 11 N.m (97 lb in).

4. Connect the CKP sensor electrical connector.
5. Install the right front wheel.
6. Lower the vehicle.
7. Perform the CKP system variation learn procedure. Programming and Relearning