Scan Tool Data Definitions

SCAN TOOL DATA DEFINITIONS

Software Part Number: Part number of component program or the ECU. Used to determine applicability to vehicle RPO content.

Accessory Switch: Input from ignition switch ACCESSORY circuit. Used to determine power mode. Hot in ACCESSORY and RUN.

Electronics Battery Fd: Data indicates the voltage detected by the control module on the power circuit for the module internal devices.

Electronics Battery Fd: Input indicates the completion state of the power circuit for the module internal devices.

Electronics System Gnd Indicates the completion state of the ground circuit for the module internal devices.

Ignition 0: Input to the control module from the ignition switch indicating the state of the Ignition 0 signal.

Ignition 1: Input to the control module from the ignition switch indicating the state of the Ignition 1 signal.

Key Cylinder Unlock: Input from front door key cylinders.

Key in Ignition: Input from ignition switch indicating that the ignition key is inserted into the ignition switch. HOT with key in ignition and ignition switch position LOCK.

Load Management Status Output indicating the power mode commanded.

Loads Battery Fd: Indicates the completion state of the supply circuit for the high current loads.

Loads System Gnd: Indicates completion state of the ground circuit for the high current loads.

Restraints ID: Indicates the type of restraint system on the vehicle and recognized by the control module.