PES

Sunroof Track Timing/Synchronization (PES)

Removal Procedure

1. Remove the headliner.
2. Disconnect the electrical connector from the motor/actuator.
3. Remove the motor/actuator.
4. Remove the screw that attaches the control module.





5. Install a pin temporarily in the holes to hold the position while installing the drive motor.
6. Remove the sunroof window.
7. Manually slide the mechanism forward in the track until the mechanism reaches the hard stop.





8. Push the cam assembly (2) forward until the timing hole (3) in the cam is aligned with the timing hole (4) in the lifter arm (1).

Important: Both mechanisms should now be in the closed position.

9. Repeat this procedure for the opposite side.

Installation Procedure

Notice: Refer to Fastener Notice in the Preface section.

1. Install the sunroof window.

Tighten
Tighten the screws to 4 Nm (35 lb in).





Important: Before installing the sunroof opening position switch, inspect the timing window. The small hole must be in line with the bar, as shown. If the hole is not aligned with the bar, rotate the gear by hand left or right until the hole and the bar are in position.

2. Install the control module.
3. Install the motor/actuator.





4. Remove the pin that was installed to temporarily hold the position of the sunroof opening position switch.

Tighten
Tighten the motor/actuator attachment screws to 3.5 Nm (31 lb in).

5. Connect the electrical connector to the motor/actuator.
6. Install the headliner.

Important: If the sunroof does not function properly, and the guides are parallel, then replace the sunroof opening switch.

7. Verify the operation of the sunroof.