Sunroof Module Assembly Replacement (PES)

Sunroof Module Assembly Replacement (PES)

Removal Procedure

Important: A new sunroof module assembly will not have the sunroof window or sunshade as components of the new service part.

1. The old sunroof window and sunshade will need to be installed to the new sunroof module assembly.
2. Remove the sunroof window.





3. Remove the sunshade panel.
4. Remove the headliner.
5. Disconnect the electrical connector from the sunroof module.





6. Disconnect the front and rear drain hoses from the sunroof module.





7. Have an assistant support the sunroof module.
8. Remove the bolts from the sunroof module.
9. Remove the sunroof module from the vehicle with an assistant.

Installation Procedure





1. Position the sunroof module to the vehicle roof with an assistant.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the sunroof module bolts.

Tighten
Tighten the sunroof module bolts to 10 Nm (89 lb in).





3. Connect the front and rear drain hoses to the sunroof module.





4. Connect the electrical connector to the sunroof motor/actuator.
5. Install the sunshade panel.
6. Install the sunroof window.
7. Check for proper operation of the sunroof.
8. Install the headliner.