Trunk / Liftgate Switch: Service and Repair

REAR COMPARTMENT LID SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Release the LH instrument panel (IP) insulator tabs from the lower IP trim pad retainers for access.
2. Remove the LH fuse block access cover.
3. Remove the steering column opening filler panel screws.
4. Release the steering column opening filler panel retainers from the IP lower trim panel. Carefully lower the steering column opening filler panel away from the IP lower trim panel.




5. Disconnect the electrical connector from the rear compartment release switch.
6. Remove the rear compartment release switch.

INSTALLATION PROCEDURE




1. Install the rear compartment release switch.
2. Connect the electrical connector to the rear compartment release switch.




3. Align the steering column opening filler panel to the instrument panel (IP) lower trim panel. Install the steering column opening filler panel retainers to the IP lower trim panel.
NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the steering column opening filler panel screws.

Tighten
Tighten the steering column opening filler panel screws to 2 N.m (18 lb in).

5. Install the LH IP insulator tabs to the lower IP trim pad retainers.
6. Install the LH fuse block access cover.