Fog/Driving Lamp Switch: Service and Repair
FOG LAMP SWITCH REPLACEMENT - FRONTREMOVAL PROCEDURE
1. Remove the trim plate bezel from the instrument panel (I/P) cluster.
2. Remove the headlamp switch assembly screws.
3. Pull the headlamp switch assembly from the I/P.
4. Disconnect the electrical connector from the fog lamp switch.
5. Remove the fog lamp switch from the back of the headlamp switch assembly.
INSTALLATION PROCEDURE
1. Install the fog lamp switch through the back of the headlamp switch assembly by pressing the switch into place until fully seated.
2. Connect the electrical connector to the fog lamp switch.
3. Install the headlamp switch assembly to the I/P.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the headlamp switch assembly screws.
Tighten
Tighten the screws to 2 N.m (18 lb in).
5. Install the trim plate bezel.