Instrument Panel Cluster (IPC) - Trim Panel Replacement
Trim Panel Replacement - Instrument Panel (I/P) Cluster (Chevrolet)
Removal Procedure
1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in Restraint Systems.
2. Remove the instrument panel (I/P) trim pad.
3. Remove the screws (1) from the I/P cluster trim panel (3).
4. Remove the I/P cluster trim panel (3). Pull rearward in order to disengage the retainers (2).
5. Disconnect the electrical connectors for the headlamp dimmer switch.
6. Disconnect the electrical connector for the cigar lighter, if equipped.
Installation Procedure
1. Connect the electrical connector for the cigar lighter, if equipped.
2. Connect the electrical connectors for the headlamp dimmer switch.
3. Align the retaining tabs (2) with the I/P carrier.
4. Install the I/P cluster trim panel (3). Press the plate into the I/P carrier to engage the retainers (2).
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the screws (1) to the I/P cluster trim panel (3).
Tighten the screws to 2.3 N.m (20 lb in).
6. Install the I/P cluster trim panel (3).
7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in Restraint Systems.