Instrument Panel Electrical Center or Junction Block Replacement

INSTRUMENT PANEL ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT

REMOVAL PROCEDURE
1. Disconnect the negative battery cable.




2. Remove the outer trim covers (1,3) from the Instrument Panel (I/P) carrier (2).




3. Loosen the outboard junction block electrical connector bolt. Disengage the outboard junction block electrical connector tabs from I/P fuse block. Left side shown, right side similar.




4. For the driver side only:
1. Remove the left half of the sound insulator from the I/P carrier and disengage the wire harness from the cross vehicle beam.
2. Disengage the I/P fuse block tabs from the cross vehicle beam.
3. Pull the I/P fuse block away from the I/P carrier.
4. Loosen the inboard junction block electrical connector bolts. Disengage the junction block electrical connector tabs from the I/P fuse block.
5. Note where the fuses and relays are located and remove if required.




5. For the passenger side only:
1. Remove the I/P storage compartment from the I/P carrier.
2. Through the opening in the I/P storage compartment, loosen the inboard junction block electrical connector bolts. Disengage the inboard junction block electrical connectors tabs from the I/P fuse block.
3. Disengage the IP fuse block from the cross vehicle beam and remove the passenger side fuse block from the I/P carrier.
4. Note where the fuses and relays are located and remove if required.

INSTALLATION PROCEDURE
1. Install fuses and relays to the fuse block if required.




2. For passenger side only:

NOTE: Refer to Fastener Notice in Service Precautions.

1. Place the fuse block through the I/P carrier.
2. Through the opening in the I/P storage compartment connect the inboard junction block electrical connectors to the I/P fuse block.
3. Engage the inboard junction block electrical connectors to the I/P fuse block until the connector tabs are fully seated.

Tighten the bolts to 2.3 N.m (20 lb in).

4. Install the I/P storage compartment to the I/P carrier.




3. On the drivers side only:
1. Connect the inboard junction block electrical connectors to the I/P fuse block.
2. Engage the inboard junction block electrical connectors to the I/P fuse block until the connector tabs are fully seated.

Tighten the bolts to 2.3 N.m (20 lb in).

3. Engage the I/P fuse block to the cross vehicle beam.
4. Engage the wire harness to the cross vehicle beam and install the left halve of the sound insulator to the I/P carrier.




4. Install the outboard junction block electrical connector to the I/P fuse block. Left side shown, right side similar.
5. Engage the outboard junction block electrical connector to the I/P fuse block until connector tabs are fully seated.

Tighten the bolt to 2.3 N.m (20 lb in).




6. Install the outer trim covers (1,3) to the I/P carrier (2).
7. Connect the negative battery cable.